ASSEMBLY
Assembly requires two persons, Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included hex keys, assembly requires a Phillips screwdriver _, an adjustable
wrench _, and a rubber mallet c
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly. IMPORTANT: Some small parts may have been
pre-assembled. If a part is not in the parts bag, check to see if it has been pre-assembled. If a part is
missing, call 1-888-533-1333.
M8 Nylon
Locknut (96)-4
M6 Split M10 Spacer M10 Split Wave Washer
Washer (88)-8 (76)-2 Washer (72)-2 (93)-6
M4 x 16mm
Screw (86)-4
M4 x 16mm M4 x 16mm M4 x 12mm
Self-tapping Flange Screw Flange Screw
Screw (79)-10 (84)-2 (73)-6
M4 x 65mm Screw (91)-4
\
M10 x 20mm x M10 x 25mm x
2mm Washer 1.5mm Washer
(81)-4 (83)-8
M6 x 16mm Phillips
Screw (87)-8
M8 x 16mm Button
Screw (95)-3
M8 x 42mm Button Bolt (71)-4
MIO x 23mm Shoulder
Screw (80)-8
M10 x 15mm Button
Screw (82)-4
M10 x 48mm Button Screw (78)-2 M10 x 62mm Button Bolt (97)-2
M10 x 35mm Shoulder
Screw (94)-2
To Next Page
Loading...
