12 © 2008 by Proceq SA
3 Real Tests
Overview
Read the
Tutorial
Understanding the boundaries of the pulse induction principle
Complete
Getting Started
Check the operation of your Profoscope with
the start-up test kit
Regional Settings Change default settings to your regional standard
What Do You
Want to Do?
3.2
Locate a Rebar
No further
Settings necessary
Locate the Rebar
Check the
Orientation
Place center line directly over rebar•
3.3
Measure
Cover Depth
Key-in Rebar
Diameter
Place Center Line
Directly over Rebar
Read off Cover Depth
An accurate rebar diameter setting will •
give an accurate cover depth result
Activate neighboring bar correction if •
necessary
Create Rebar Grid
Check minimum bar spacing•
3.4
Measure Rebar
Diameter
Determining
Unknown Rebar
Diameter
Work with Default
Known error tolerances given in the •
Tutorial section
Drill Inspection Hole
Remove all doubt•
Real Tests
To Next Page
Loading...