© 2008 by Proceq SA 5
Table of Contents
Getting Started 2
Overview of the Profoscope 3
The Profoscope Display 4
1 Safety and Liability 6
1.1 Safety and Usage Precautions 6
1.2 Liability 6
1.3 Safety Instructions 6
1.4 Labelling Used in the Manual 6
2 Tutorial 7
2.1 The Measurement Principle 7
2.2 The Measuring Range 8
2.3 Factors Affecting the Measurement 8
2.3.1 Errors due to Neighboring Bars 8
2.3.2 Resolution 9
2.3.3 Effect of Setting Incorrect Bar Diameter 10
2.3.4 Factors Affecting Diameter Determination 11
2.3.5 Orientation 11
3 Real Tests 12
3.1 Preparation 13
3.2 Locate a Rebar 13
3.2.1 Finding a Rebar 13
3.2.2 Check the Orientation 16
3.2.3 Verification 17
3.2.4 Locate a Mid Point 17
3.2.5 Map out the Rebar Grid 17
3.2.6 Advanced Settings (Measuring Range) 18
3.3 Measure Cover Depth 18
3.3.1 Set the Rebar Diameter 18
3.3.2 Read the Cover Depth 19
3.3.3 Advanced Settings (Neighboring Rebar Correction) 19
3.3.4 Advanced Settings (Minimum Cover Alert) 19
3.4 Measure Rebar Diameter 20
3.4.1 Determining Unknown Rebar Diameter 20
3.4.2 Create a Rebar Grid 20
3.4.3 Work with a Default Value 21
3.4.4 Drill Inspection Hole 21
4 General Settings 22
4.1 Navigating 22
4.2 Regional Setting 22
4.3 Bar Diameter 23
4.4 Measuring Range Selection 23
4.5 Audio Setting 24
4.6 Minimum Cover 24
4.7 Neighboring Bar Compensation 24
5 Technical Specifications 25
6 Part Numbers and Accessories 26
7 Maintenance and Support 27
7.1 Replacing the Protective Cover 27
7.2 Support Concept 27
Subject to change without notice.
820 39 101E ver 09 2008
To Next Page
Loading...
Need help?
General