Progeny C4 - Credentials (Cards & Fobs); Adding Credentials; Block of Credentials

Document # MAN0001 Issue 4.29 Page 15 of 34
Credentials (Cards & Fobs)
Adding Credentials
Adding or enabling credentials by
entering the Identification Number (ID)
can be useful when the credentials
themselves are not available or if a
large number of credentials need to be
added.
Single Credential:
Note: Some Credentials have a serial
number printed on them. This should
be used with the cross-referenced list
provided with the Credentials, to
determine the actual Credential
number.
This example will enable a single Credential numbered 00026317
Block of Credentials
The quickest way to enable a whole
group of Credentials is to use the
“block add” method shown in this flow
diagram.
The principle is to enter the ID of the
first credential in the sequence and
then specify the quantity to be added.
This example will enable 50 ID’s, from
Credential 00026300 to 00263049.
Related User Menus:
• 05 “Remove Credential”
Related Engineer Menus:
• 20 “Keypad Mode”
Status LED will Flash
Enter User Password
* 6 5 4 3 2 1
Select Add CredentialMenu * 0 4
Enter Credential ID or Present Credential 0 0 0 2 6 3 1 7
Status LED will stop Flashing
Complete & Exit Programming Mode
#
Status LED will Flash
Enter User Password
* 6 5 4 3 2 1
Select Add CredentialMenu * 0 4
Enter Quantity ( 1 to 200 ) 50
Status LED will stop Flashing
Complete & Exit Programming Mode
#
Enter Credential ID 0 0 0 2 6 3 0 0
Enter * as a separator *