18
User Manual | Agrónic 2500
Parameters | Programs
The programs are those that manage crop irrigation
and fertilization. They control the opening and closing
of sectors and fertilization. The Agrónic 2500 has 50
programs.
PROGRAM PARAMETERS
Program: 12
Type of start: [ schedule ]
[ sequential ]
[ input ]
Units of irrigation: [ hh:mm ]
[ m3 ]
Program 12
Pre-irrigation: 00:00
Post-irrigation: 00:00
Program (00 ... 50): program number to be configured.
Start-up type (schedule | sequential | input):
determines
how the program is to be started.
• Schedule: starts at a certain time.
• Sequential: starts when another program ends.
• Input: starts when the IP input is activated.
5.4. PROGRAMS
If the Sequential with 99:00 option is activated in
‘Function - 4. Parameters - 8. Installer - 5. Various’,
changing the start schedule to sequential can be
entered in the program. There is no need to do it from
parameters.
Irrigation Units (hh:mm | m3): determines which units
the program will use for irrigation. When the units are
volume (m3), the irrigation meter must be configured.
• hh:mm: hours and minutes.
• m3: cubic meters.
Pre-irrigation (00:00 ... 99:59): time or volume that
must transpire before starting fertilization. The units
and format are the same as irrigation. At 0, fertilization
begins the same as irrigation.
Post-irrigation (00:00 ... 99:59): time or volume that
must transpire between fertilizing termination and
the program termination. The units and format are
the same as irrigation. If fertilizing has not yet finished
when it arrives at post-irrigation, it stops and anomaly
26 is recorded. If irrigating and fertilizing by time and
the fertilization is series or parallel, there is no need to
run pre-irrigation. It is automatically calculated based
on the post-irrigation and fertilization time.
Video tutorial
available for
this section
To Next Page
Loading...
