5
User Manual | Agrónic 2500
FERTILIZATION
Configurabe from 0 to 4 fertilizers in separate tanks.
Separates pre- and post-irrigation values in each
program. Cleaning the injectors aer fertilizing. Fer-
tilization units in time (hh:mm), in volume (L). Config-
ured to use mixers, with pre-mixing and intermittent or
continuous mixing.
Fertilizers can be applied in two ways:
Control up to 30 sectors using 50 irrigation programs.
Each program can activate 1 to 4 irrigation sectors si-
multaneously.
There are three ways to start a program:
schedule start: at a specific time choosing the days of
the week.
Days of the week
Sequential start: when another program has finished.
It is used to irrigate several sector groups one aer
another. The first program in the sequence must be
schedule start or conditional.
P6 sequential of P5 and P7 sequential of P6, etc.
Conditional start: when the contact closes the program
start input (CS).
Conditional start due to frost
The programs can be stopped, before the irrigation
ends, by three digital malfunction inputs.
Temporary malfunction (TM): stops the current irriga-
tion but allows the next one to start.
Definitive malfunction (DM): for all programs and must
be reset manually.
Conditional stop (CS): stops the program while the
contact is closed, when it is opened the program
resumes at the last point where it was.
Irrigation units can be in time (hh:mm) or volume (m3).
A record is made of the irrigation time and volume for
each sector and in total.
2 FEATURES
The Agrónic 2500 is a controller for controlling irrigation, fertilization, pumping and filter cleaning.
It detects malfunctions and creates a chronological record of the events. Fully configurable, with
multiple possibilities for use, communication and expansion.
IRRIGATION
To Next Page
Loading...
