24
User Manual | Agrónic 2500
7 PRACTICAL EXAMPLES
The examples in the manual are summarized. To see the step-by-step explanation of how to do it,
please go to our website. There are many more examples that may be useful to you.
Configure the irrigation meter
First find out which digital input the meter is connected
to. Then go to ‘Function - 4. Parameters - 3. General’
(see section 5.3) and enter that input in CR. Configure
the pulse value and the maximum time between
pulses for the meter malfunction. In ‘Function - 4. Pa-
rameters - 5. Sectors’ enter which sectors use water
from that meter. By default, all sectors are configured
to use the meter.
Connect a diesel generator with a control
unit
If you have a unit with the diesel option and a generator
with a control unit, it may be that only a contact signal
is required for the generator. In this case, set the start
and stop time to 0 (Diesel option).
Save a copy of the parameters and pro-
grams
The Agrónic allows you to save a copy of all the pa-
rameters and programs that can be recovered when
necessary. To make the copy or recover the last copy
created, go to ‘Function - 4. Parameters - 8. Installer -
9. Backup parameters’. If there is a saved copy, enter
the date and time it was made. You can recover the
saved copy or create a new one.
Protect the Agrónic against theft
The Agrónic has an anti-the system with a 4-digit pin
code. If the Agrónic is disconnected for more than 10
minutes, the pin code is requested when it reconnects
(Various).
More practical
examples on
our website
To Next Page
Loading...
