22
User Manual | Agrónic 2500
Parameters | Various
• Volume format (00000 | 0000.0 | 000.00): when the
units are by volume, here you determine which
format you want to work in.
Fertilization
• Fertilizing type (series | parallel): it indicates how
the fertilizers are injected into the irrigation, one
aer another (series), all at the same time (parallel).
• Fertilizing units (hh:mm | liters): indicates which fer-
tilizing units will be used: time (hh:mm) or volume
(liters) . These units are common for all programs.
Irrigation units are configured for each program.
• Stop when cleaning filters (No | Yes):
‒ Yes: the fertilization is temporarily stopped
when the filters are cleaned.
Inputs and outputs
• Latch valve (2 wires | 3 wires | 2 w.inv): if the base of
the Agrónic is latch, you can configure what type of
solenoids. If 3-wire is selected, outputs M1 and M2
can be configured as 2-wire latch.
• Latch voltage (12 V | 22 V): the latch trigger voltage
is selected.
• Pump1-Tension latch (12 V | 22 V): latch trigger
voltage for P1.
• Pump1-Latch time (93.7 | 125.0 | 156.2 | 187.5 | 218.7
| 250.0 | 281.2 | 312.5 | 343.7 | 375.0 | 406.2 | 437.5 |
468.7 | 500.0): latch trigger time for P1.
• Pump2-Tension latch (12 V | 22 V): latch trigger
voltage for P2.
• Pump2-Latch time 93.7 | 125.0 | 156.2 | 187.5 | 218.7
| 250.0 | 281.2 | 312.5 | 343.7 | 375.0 | 406.2 | 437.5 |
468.7 | 500.0): latch trigger time for P2.
• Daylight saving time (No ... Yes):
‒ Yes: the controller automatically changes from
winter to summer schedule.
• Digital Meter Sensor Anti-bounce Filter (00.0 ...
10.0”): you can define a time for the back-torque
filter for the base meter inputs (00.0 no filter). This
value is the minimum time that the meter pulse
needs to be active for the total value to increase.
A pulse lower than this time does not increase the
total value.
5.6.6 Communications
See the ‘1850 Agrónic 2500 Communications’ manual.
5.6.7 Language
The available languages are Spanish, English, French,
Italian, Portuguese and Catalan.
5.6.8 Update software
To update the Agrónic 2500 soware by connecting it
to a PC using a USB cable.
5.6.9 Backup parameters
Saves a copy of all the Agrónic parameters and
programs in an internal flash memory. This copy can
be recovered whenever desired, leaving the unit with
the same configuration as when it was saved.
To Next Page
Loading...
