37
Trouble shooting
Product Support
Image persistence - ghosting Remote control - does not operate
Remote control - does not operate
No power
Poor picture
No picture
No sound
Please note that ghosting may occur while displaying a
persistent image (still or paused image). LCD TVs’ image
persistence may disappear after a short time. Try turning
off the TV for a while. To avoid this, do not leave the
screen in still picture mode for extended periods.
<RXU79QRORQJHUUHVSRQGVWRWKHUHPRWHFRQWURO7KH
batteries may be exhausted, if so you can still use the
control buttons on the left side of the TV.
1. If you cannot select an input source, it is possible that
no device is connected.
2. Check the AV cables and connections if you have tried
to connect a device.
If your TV has no power, please check the power cord
plug is connect to the mains power socket.
1. Have you selected the correct TV system?
2. Is your TV or house aerial located too close to a
QRQHDUWKHGDXGLRHTXLSPHQWRUQHRQOLJKWVHWF"
3. Mountains or high buildings can cause double pictures
or ghost images. Sometimes you can improve the picture
TXDOLW\E\FKDQJLQJWKHGLUHFWLRQRIWKHDHULDO
4. Is the picture or teletext unrecognisable?
&KHFNLI\RXKDYHHQWHUHGWKHFRUUHFWIUHTXHQF\
5. Please retune the channels.
7KHSLFWXUHTXDOLW\PD\GHJUDGHZKHQWZRGHYLFHVDUH
connected to the TV at the same time. In such a case,
disconnect one of the devices.
1. No Picture means that your TV is not receiving a
transmission. Make sure the correct input source has
been selected.
2. Is the aerial connected properly?
3. Are the plugs connected tightly to the aerial socket?
4. Is the aerial cable damaged?
5. Are suitable plugs used to connect the aerial?
6. If you are in doubt, consult your dealer.
1. Has the TV been set to mute? To cancel mute, press
the “ ” button, or increase the volume level.
2. Sound is coming from only one speaker. Is the balance
set to one extreme?
Downloaded from www.vandenborre.be
To Next Page
Loading...
