3. Place the upper part back on the lower part and tighten the four screws
hand-tight.
ð
The sensor must be reset in order to enable detection of the new
drying agent. In order to do so, remove the sensor connection cable
for 2 seconds and then re-connect it. Otherwise the
[DESC]
warning
may be shown on the LCD display.
6.2 Routine measurement
Routine measurement: The turbidity
can be correctly measured approx. 45
- 60 minutes after beginning measure‐
ment / commissioning (warm-up
phase).
If a continuous process water flow
passes through the sensor, then the
sensor shows you the measured tur‐
bidity level of the sample on the LCD
display. In addition, a 4-20 mA signal
or a digital signal is given, depending
on the selected option.
Commissioning
33
To Next Page
Loading...
Need help?
General
