Name: ProMinent DULCO turb C Series
Brand: ProMinent
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Function Options Info

Addr 1 ... 255 Selection of the device

address

MBUS ASCII

RTU

Selection ASCII or RTU

6.4.2 Configuration of fault current (ERLV)

A0625

Fig. 11: Configuration of fault current (ERLV)

The 4-20 mA signal output can be utilized in the event of a system error on the

DULCO

turb C in order to indicate the problem by activating the

[ERLV ON]

function. In doing so, fault currents of 4.00 mA, 2.00 mA or 0 mA can be

selected. In the event of an error, the configured current value is output to the

controller, regardless of which measured value is pending. If the function is

switched off by setting

[OFF]

then the 4-20 mA signal output remains unaffected

by fault conditions.

Commissioning

Questions and Answers:

Need help?

Do you have a question about the ProMinent DULCO turb C Series and is the answer not in the manual?

ProMinent DULCO turb C Series Specifications

General