If you have set the extended settings
(EXTD) to
„ON“
then you can use the
[↲]
-button after the final menu in the
extended settings to save your set‐
tings and return to the permanent dis‐
play in
„AUTO“
mode, see figure
Fig. 6. All changes previously under‐
taken in the configuration menu can
be stored in this manner.
You can access the configuration
menu at any time in order to reset or
modify some or all of the parameters.
You can exit the configuration menu
at any time by pressing the
[MODE/EXIT button]
. In doing so,
any changes to the parameters that
you have modified will be stored.
Flow controller
The flow controller (part number
1037880) limits high-pressure sys‐
tems to a flow of less than 1 l/min.
Commissioning
54
To Next Page
Loading...
Need help?
General
