2 Integrating the device and the function block into your own
project
Note: This description cannot go into all the details of PRO‐
FIBUS
®
communication.
If necessary attend an appropriate training course.
2.1
Add PROFIBUS
®
Master System
This section describes how to add a PROFIBUS
®
Master System into your
own project and how to generate a PROFIBUS
®
subnet:
1. Double click to open your own project (shown here with a red
border) that you created in chapter 1.1:
Fig. 3
2. Double click the
“Hardware”
symbol to open the Hardware Configu‐
rator:
Fig. 4
Integrating the device and the function block into your own project
11
To Next Page
Loading...
