Whenever AUTO SEARCH for TV channel is performed, tuned TV channel or programs are stored in sequential order as channel
0, 1,2, etc. To set a particular TV channel to specific channel number, follow the steps below:
1.
2.
3.
4.
5.
6.
7.
8.
Press the MENU key on the remote control to display the TV menu.
Press the DOWN arrow key one time to highlight TV SETTING then press the MENU button to select.
Press the UP or DOWN arrow key to highlight SWAP and press MENU to confirm selection.
Under "CHANNEL", use the left and right arrow keys to select channel to be swapped.
Use the up or down arrow keys to highlight "TO" and press the right arrow key to confirm selection.
Use the left or right arrow keys to select the channel number to be swapped and press MENU key to confirm channel
swap.
Repeat step 4 to 6 for another channel swap.
Press EXIT key four times to exit the TV menu upon completion of channel swap..
Note: Channel mapping (frequency) table can be found at the end of this manual if needed.
15
To Next Page
Loading...
