Ifaparticularchannelisnotbeingreceivedclearlyonyourunityoumayfine-tunethechannel,whichmayimprovethereception.
Go the channel that you wish to fine tune, then
1. Press MENU and scroll down to TV SETTING by pressing the DOWN key once.
2. Press MENU to select TV SETTING
3. Scroll down to AUTO FINE and press MENU to select then press RIGHT arrow until YES is shown
4. Press EXIT to select and the channel will be automatically fine-tuned.
If this does not result in acceptable reception
1. Go back into the TV SETTING menu as described above and select FINE TUNE.
2. Press MENU to highlight to frequency bar and use the LEFT and RIGHT arrow buttons to adjust reception manually.
3. When the best reception is achieved press EXIT to set and again to exit from the menu system.
When you first scanned the channels when setting up your unit, the memory may have memorized some channels that you do not
want to watch.
To remove channels from the memory:
1. Go to the channel you wish to remove so you are watching it on your screen
2. Press MENU then the DOWN arrow once to TV SETTINGS and press MENU to select
3. Press the DOWN arrow twice to highlight SKIP THIS and press MENU to select
4. Press the right arrow key to select YES and press EXIT three times to select and exit the MENU system
The channel will appear on the screen, but when you change channels and go back to the channel you removed it will not be
there.
Note: To restore a channel that you have previously removed you must rescan all channels as described above under "Scanning
Channels".
19
To Next Page
Loading...
