16.2 IP Routing Topology
This IP Routing topology that the cellular router connects Router-1 as result.
(1) PC-A sends ICMP packet to Router-1 LAN and WAN IP and they should have response.
Note: Router-1 is pure router and should be supported "NAT enable / disable".
LAN configuration:
There are one example to introduce how to work for routing.
Example 1: Add IP Routing on LAN interface
Step 1: The cellular router for Static Route configuration
The Mode is on at the settings section and add the routing.
Step 2: Router-1 configuration is as below.
(1) Login to the Router-1 web site, and then "NAT disable".
(2) Configure LAN IP: 192.168.10.1
(3) Configure WAN IP: 192.168.1.50
To Next Page
Loading...
