Proscend M302-L - SNMP V3 User Configuration

INDUSTRIAL 4G LTE CELLULAR ROUTER – B_UM V1.1.0
82
12.1.2 SNMP v3 User configuration
For SNMP version 3, you need to register authentication and allow a receiver that confirm the
packet was not modified in transit. There are three options to set up SNMP v3 configuration.
Service > SNMP > Community
Item
Description
Mode
Select from Disable or Enable to configure SNMP.
Community
Configure community setting with three options, including # 1, # 2
and #3.
Mode
Select from Disable or Enable.
Name
Name each community.
Access
Select from Read-Only or Read-Write.
Service > SNMP > SNMP v3 User configuration
Item
Description
Mode
Select from Disable or Enable to configure SNMP. The default is
Disable.
Name
Fill in your name.
Auth Mode
Select from Authentication or Privacy.
Authentication Password
Fill in your authentication password.
Authentication Protocol
Select from MD5 or SHA.
Privacy Password
Fill in your privacy password.
Privacy Protocol
Select from DES or AES.
Access
Select from Read-Only or Read-Write.