14
If the maximum time has been set, the next press of the OVERRIDE button will reset the timer and return the thermostat
to the correct time period program for the day.
Occupied Operation - During programmed, occupied periods, pressing the OVERRIDE button will force the thermostat
into an unoccupied period for the rest of the day. During this forced unoccupied period the OVERRIDE button will operate
as described above
Viewing the Temperature Sensors
OUTDOOR/REMOTE/SUPPLY TEMP – Press the Accessory Status button. If an Outdoor sensor is connected,
the reading along with the high and low temperatures for the day will be displayed. The high and low
temperatures reset at 12:00 am. If connected to a ProStat+ Skyport account, the temperatures for your zipcode will be
shown unless a wired sensor is connected. Press the MODE button to view any connected remote or supply sensors
and other accessories.
Viewing the Indoor Humidity Sensor
IMPORTANT: Allow at least 2 minutes after the thermostat is powered on for the humidity to read correctly.
Press the HUMIDITY button then the mode button to display the current humidity measured at the thermostat. The room’s
relative humidity is displayed in the top left corner. The humidification setpoint appears in the larger, center display and can
be adjusted using the WARMER or COOLER buttons. Press the MODE button again to view and adjust the dehumidification
setpoints. Press the HUMIDITY or MODE button again to confirm settings and return to normal operation.
Note: Due to variations in environmental and equipment conditions, it is not always possible to achieve the desired
humidification or dehumidification setpoint.
HUMIDITY
PSP4272C User Manual.indd 14PSP4272C User Manual.indd 14 6/9/21 11:05 AM6/9/21 11:05 AM
To Next Page
Loading...
Need help?
General
