Protectowire FiberSystem 8000 User Manual

Troubleshooting and Maintenance
To clean these connectors thoroughly, open the enclosure
door.
Remove the connector from the panel adapter.
Open the dust cap on the connector tip using
service adapter.
3.
4.
the E2000
5.
Clean the end face of the connector:
a) Gently rub the connector end against an absolute clean
are a of a cleani ng pape r. Be sure th e pape r i s not
contaminated by dust or fingerprints. We recommend to
discard a sheet after giving it out of the hand.
b) For thorough cleaning, the dirt shall be wiped away using
pure Isopropanol. Spill some drops Isopropanol on a small
area of the cleaning paper. Gently rub the connector end
over this location, then before the connector dries, rub it
against a dry area.
30
The Protectowire Company, Inc.
FIBERSYSTEM 8000 - Linear Heat
Series

Protectowire FiberSystem 8000 Specifications

General

Brand	Protectowire
Model	FiberSystem 8000
Category	Controller
Language	English