P2_GEPARD_installer manual_ work basis_EN_02 - 03/10 - protherm
- 3 -
INTRODUCTION
INTRODUCTION
Manual1
Product documentation1.1
Instructions are included with the device and after the
installation must be handed to the user in accordance with
applicable regulations.
Study the handbook carefully to ensure a safe installation, •
safe use and proper service. W
e are not responsible for
any damage resulting from failure to follow the instructions
presented in this handbook.
Relevant documents1.2
Contents of the boiler is the following documentation:
user manual, warranty card, a list of service centers, service
book
Explanation of symbols1.3
a
DANGER: Risk of injury.
e
DANGER: Risk of electric shock.
b
CAUTION: Risk of damage to the equipment or
its edge parts.
i
IMPORTANT: Useful information.
Description of the device2
Safety regulations 2.1
The following regulations and safety instructions must be
observed:
Never tamper with the safety devices.•
Do not modify the equipment or its immediate surroundings, •
as this could affect the safe use of the boiler.
Do not under any circumstances destroy or remove the •
sealing from any of the parts.
Never carry out alone any maintenance or repairs to the •
equipment. Only qualifi ed technicians may work with the
equipment.
Be careful not to allow children to play with the boiler.•
Do not plug or obstruct the ventilation system.•
Some home “improvements” may signifi cantly affect the
functioning of the boiler. Before carrying out any such
intervention you must consult with the installer.
Do not site the equipment in excessive dampness.•
Do not use and do not store explosive or fl ammable •
materials (e.g. gasoline/petrol, aerosols, thinners, chlorine-
based cleaning agents, paints, glues etc.) in the same space
as the boiler. Under certain conditions these materials may
be corrosive.
Do not touch the equipment surfaces - e.g. the ventilation •
pipes, hydraulic connectors and so on — even after the
boiler has been turned off, as these surfaces may be hot.
Touching these surfaces may lead to burns or scalding.
Be prudent when using the hot water tap. Water coming out •
of this tap may be scalding.
This equipment contains metal parts (components). In working
with it and in cleaning it, particularly its corners, you must be
careful.
If water leaks from the unit you must immediately turn off •
the cold water intake and the leak must be repaired by a
qualifi ed technician.
Do not store any objects on top of the equipment.•
Product label2.2
Type the label indicates the country where the equipment was
manufactured and the country where the equipment may be
installed.
Location of the manufacturing label:
Production label is located on the back of the electrical box. It is
accessible by tipping the entire electrical box.
On the label is the type of boiler designation, serial number, the
appliance category, type and inlet gas pressure, CH maximum
pressure, DHW maximum pressure, the maximum temperature
in the boiler, DHW maximum fl ow, distribution, thermal output,
thermal consumption, effciency, electrical casing and coverage
certifi cation marks.
a
The device can be connected only to the type
referred to the gas to the manufacturing label.
Type of gas2.3
This boiler is for natural gas but can be converted into propane.
Natural gas: G25
Regulations and legal provisions2.4
CE mark 2.4.1
The boiler (as well as all its optional accessories) complies
with the requirements of European Directive 90/396/EEC
on gas-fuelled appliances and European Directive 92/42/
EEC on effi ciency, the European Directive 2006/95/EC on
electrical means of operation for use in certain voltage ranges
To Next Page
Loading...
