P2_GEPARD_installer manual_ work basis_EN_02 - 03/10 - protherm
- 7 -
INTRODUCTION
Safety instructions and regulations3
Safety instructions3.1
When gas pressure exceeds the limit specifi ed input device, the
device may not start.
e
Incorrect installation can cause electric shock or
damage to equipment.
Never disconnect safety devices and do not try to edit them.•
Follow these steps and ways of handling:•
Hold the device in its lower part -
Wear appropriate protective equipment, eg. gloves, safety -
shoes.
Ensure that you adhere to proper lifting practices:•
Have settled back. -
Do not rotate in the belt. -
Do not bend the upper body. -
Always take plant palms. -
Use for handles. -
Hold the load close to the body. -
If necessary, always ask for help. -
The user may not under any circumstances, interfere with •
the installation of closed or edit.
When engaging the right set seals to prevent leakage of gas •
or water.
This device contains metal parts (components) and when •
handling and cleaning them, especially the corners, you have
to be careful.
Before performing maintenance or replacement of a spare part
must be carried out basic precautions:
Turn off the device.•
Disconnect the device from the tension.•
Close the valve to supply gas to the facility.•
Hydraulic disconnect device by isolating valves, if they were •
delivered.
If you replace the hydraulic components that allow the device •
off.
While working with the device, protect all the electrical parts •
from contact with water.
Use only original spare parts.•
Use only new O-rings and gaskets.•
Upon completion of work on gas or water components of •
check seal.
After the intervention, test the equipment to service and •
safety check.
To Next Page
Loading...
