Proto REFLEX RAIL - Loaders, Air, and Regulator Systems; Loader Attachment and Feed Neck

LOADERS AND FEED NECK
LOADERS AND FEED NECK
To achieve the maximum
performance of the REFLEX RAIL™
you will need to use a motorized
loader that force-feeds paintballs
into the REFLEX RAIL™ marker,
preferably the Rotor™ Loader.
Using a slower motorized loader
or a non-motorized loader will
work, but the rate of fi re and
performance will be reduced.
TO FIT A LOADER ONTO THE
REFLEX RAIL™:
The Cam Lever Feedneck is
adjustable to fi t any standard
loader. To adjust the cam locking
system, lift the cam lever away from the feed collar, and rotate the lever clockwise to tighten or
counterclockwise to loosen the grip on the loader. Once the cam lever is facing in the forward
direction, press the cam lever down against the feed collar to secure the loader in the feedneck.
To loosen the locking system and remove the loader, lift the cam lever away from the feed collar.
Take care not to over-tighten the cam locking system. The lever should not be overly diffi cult to
lower into the locked position.
W W W . P R O T O P A I N T B A L L . C O M
18