VELOCITY ADJUSTMENT
The velocity of the RAIL™ is adjusted by adjusting the input
pressure into the RAIL™. This is controlled with the Hyper3™
regulator. The Hyper3™ on the RAIL™ is factory set to 150 psi which
will give you a velocity of about 285 FPS (Feet per Second).
A 3⁄16” allen key will be needed for this operation. Turning the
adjustment screw in (clockwise) will decrease the pressure, and
out (counterclockwise) will increase the pressure. To adjust the
velocity:
1. Make sure you and everybody around you is wearing ASTM/CE
approved paintball goggles.
2. Shoot the RAIL™ over a paintball chronograph.
3. To lower the velocity turn the Hyper3™ adjustment screw in.
To increase the velocity turn the screw out. Only turn the screw
a quarter turn at a time and shoot over the chronograph again.
Notice that a few shots are needed before the change can be seen
on the chronograph.
MAINTENANCE
For the REFLEX RAIL™ to function properly, it is essential that the
input pressure into the marker stays consistent at all times. The
general maintenance needed for the Hyper3™ regulator is to keep
it clean of dirt and debris at all times. A more extensive service
should be performed every 12 months by a trained Tech or if the
output pressure of the regulator doesn’t stay consistent. This can
be seen as inconsistent velocity and verifi ed with a regulator tester
(sold separately). Notice that the Hyper3™ has a break in period of
about 2000 shots before it achieves the best performance.
HYPER3™ IN-LINE REGULATOR
ADJUSTMENTS AND MAINTENANCE
W W W . P R O T O P A I N T B A L L . C O M
20
To Next Page
Loading...
