EasyManua.ls Logo

Proto REFLEX RAIL - Performance and Feeding Issues

Default Icon
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TRIGGER BOUNCE / REFLEX RAIL™ SHOOTING
MORE THAN ONE BALL PER PULL IN SEMI
AUTOMATIC MODE
Raise the trigger sensitivity level in the
confi guration mode.
Check that the trigger is not adjusted too short.
Make sure there is a trigger spring inside
the frame.
ERRATIC VELOCITY / REFLEX RAIL™
WON’T FIRE
REFLEX RAIL™ FIRES BUT BALLS ARE
DROPPING OFF OR NOT EVEN COMING OUT OF
THE BARREL
Make sure the battery is good.
Raise the dwell to factory level (18).
Make sure bolt is well lubed and moves well.
If there is too much friction in the Bolt, it will
cause the REFLEX RAIL™ to shoot down.
Make sure air system is screwed in all the way
and Air Port is locked into on position.
FIRST SHOT IS TOO HIGH
Change the Seat inside the Hyper3™ regulator.
For disassembly instructions consult the
technical section.
Try turning off the ABS feature by turning DIP
#1 to the off position.
VELOCITY IS NOT CONSISTENT
Make sure the paintballs you are using fi t the
barrel well and are consistent in size. The stock
barrel with the REFLEX RAIL™ is .688 size.
You should be able to blow the paintball
through the barrel but they should not roll
through the barrel on their own.
Remove the bolt kit and re-lube it. Change any
O-rings causing a lot of friction. Make sure
#014 O-ring in bolt tip is in place and in
good condition.
Raise the dwell.
Change the battery.
Check that the Hyper3™ regulator is working
correctly and that the pressure is consistent.
A separate regulator-testing tool is available.
OTHER CATEGORIES
DOUBLE FEEDING
If you get two balls fi ring at once change the
ball detents on the self-cleaning Eye Pipe.
BREAKING PAINT
Make sure you use high quality paintballs and
that they are stored according to the
manufacturers instructions.
Make sure your loader is working well and
that the rate of fi re is not set higher than the
maximum feed rate of the loader.
Check that the barrel you are using is not too
tight for the paintballs you are using.
Check the condition of the ball detents.
TROUBLE SHOOTING GUIDE
W W W . P R O T O P A I N T B A L L . C O M
27

Related product manuals