SUPA8 User Manual
18
You now have a limited time to leave the premises (which will have been
preset by your installer) before an alarm is generated. If you need to re-enter
the premises, turn the system OFF, then back ON again as you leave.
NOTE: If you make a mistake when you attempt to enter your User code,
press the
* key and try again.
AWAY mode (using Quick Away)
Your installer may have programmed the SUPA8 to allow abbreviated arming.
If so, turn the system ON as follows.
1. Enter * ....................To clear the keypad
2. Enter # ...................(All Zone lights will flash - waiting for a command)
3. Enter 9 ....................Arms the SUPA8 Away mode
4. Check that the ON light turns on.
(The exit beeper will sound continuously during exit delay. If the exit
beeper has been turned off by the installer, three beeps will be heard at
the end of exit delay.)
To Next Page
Loading...