PSA Supa8 - Programming Telephone Numbers

To Next Page

To Previous Page

SUPA8 User Manual

Programming Telephone Numbers

Note: To be able to program telephone numbers the SUPA8 must be

programmed for personal dialling format.

Telephone numbers are programmed at specific addresses in the

system memory.

Addresses are: Telephone Number 1 128

Telephone Number 2 144

Temporary Telephone 112

Programming Telephone number 1

1. ____ ....................... Your Master Code

(All Zone lights will flash - waiting for a command)

2. 7........................................ To enter program mode

(ON-LINE lights flashing indicates program mode)

3. 128.............................. Address for Telephone number 1

(The existing telephone number, if any, will be displayed digit by digit)

4. ________ .... Enter the Telephone number

(Maximum 15 digits)

(If you make a mistake at this stage, press * to go back to step 3)

5. #6................................... Must be entered after the number

6. *........................................ To finish current address

At this stage you can enter the address of another telephone

number by repeating steps 3 to 6 or press

* to exit program mode.

Note: The maximum length of any telephone number is 15 digits.