SUPA8 Quick Setup
4
To DISARM the panel:
(a) On Keypad
Enter:
1234 (all Zone lights will flash)
(b) Followed by: 0 (the off key)
Step 8: Walk Test
To check operation of all Zones a Walk Test is recommended.
(a) On Keypad
Enter:
1234(all Zone lights will flash)
(b) Followed by:
5 (to initiate a walk test)
The walk test function is now activated.
The Zone LED will light as each Zone is triggered and the siren will squawk momentarily. The
Zone LEDs will remain on to show which Zone has been violated. (Requires only one person
testing).
To deactivate a walk test press the
* key.
THE SYSTEM IS NOW OPERATIONAL
To arm and disarm the system enter Master User Code 1234 (factory default) followed
by
To arm the system enter:
9 (ON)
To disarm the system enter:
0 (OFF)
Note: The system can also be quick armed by pressing
#9
To disarm enter User Code then 0
To change Master User Code or User Codes, please refer to Page 22
This completes the instruction for a Local Panel
To Next Page
Loading...