Programming Parameters
86 PT2000™ & TopGun™
Overview
This appendix provides information about all programmable settings for
the PT2000 and TopGun.
z
Table A-1: lists programming ID numbers for predefined defaults
(refer to
page 87).
z
Table A-2: lists save-and-exit settings (refer to page 87).
z
Table A-3: provides the following information (refer to page 88):
Code Parameter : is the “human” name for programming options.
ID # : is the “portable” name for programming options. For example, to
set a Code 39 minimum label length, enter
01 when programming the
portable. Programming ID numbers given in this appendix can be used
with all programming methods.
Type :
tells what kind of setting to use for each code parameter:
On/Off : is a toggle. 1 turns the parameter on, and 0 turns it off.
Value : requires a two-character entry (e.g., 02 for two beeps after each
good read, or
05 for a length of five).
String : uses one or more ASCII characters, followed by
// to indicate
the end of the string.
Immediate :
takes effect as soon as the ID number is entered.
Acceptable Input : gives the settings or range of settings that you can
use for each code parameter.
Note: For information about programming, refer to Chapter 4.
Note: For explanations of some general programming parameters,
refer to
page 66. For explanations of serial parameters, refer
to
page 68.
PT2000.book Page 86 Thursday, February 26, 2004 9:34 AM
To Next Page
Loading...