PSL PQube - Page 89

PQube User Manual 2.1
Page 89 of 113
Setup.ini Tags
Comments
Valid Values
Example
Waveform_Snapshot_At_Startup=OFF
Set this tag to ON to take a Snapshot of your
electric power every time your PQube is powered
on or reset.
ON
OFF
Enable_Snapshot_Harmonics=ON
Set this tag to ON to include a harmonics spectrum
for voltage (and current, where applicable) when a
Snapshot is generated.
NOTE: Your PQube’s sampling rate must be set to
128.
ON
OFF
[AN1_E_Events]
AN1_E_Events=OFF
Set this tag to ON to enable event triggering on
your Analog channel 1.
ON
OFF
USER_COUNTER
Dip_Threshold_In_Volts=2.00
Swell_Threshold_In_Volts=60.00
Event_Hysteresis_In_Volts=0.5
Set event detection thresholds for Analog channel
1.
[AN2_E_Events]
AN2_E_Events=OFF
Set this tag to ON to enable event triggering on
your Analog channel 2.
ON
OFF
USER_COUNTER
Dip_Threshold_In_Volts=2.00
Swell_Threshold_In_Volts=60.00
Event_Hysteresis_In_Volts=0.5
Set event detection thresholds for Analog channel
2.