PT200MI instruction manual 21
7. DISPLAYED AND OUTPUT VALUES
The relationship between gross, net and maximum display values are as follows.
Those relationships also apply to BCD and RS232/RS485 output.
(1) Gross display value = Gross value × (step width × multiplier)
TARE function will be accepted when motion is not detected.
(2) Net display value = Gross value – tare value
TARE function will not be accepted when gross display value is less than zero.
(3) Maximum display value = Maximum capacity + (9 × step width × multiplier)
When the gross value exceeds the maximum displayed value (even when the net displayed value is
being displayed), the indicator displays “O.L”, and displays the gross value when the loading is
within weighing range.
(4) Minimum display value = a value corresponding to the minimum input signal. The zero or dead load
produces a signal above the minimum input signal with an empty scale. The PT200MI will produce a
negative reading for loads below the zero load until the point the minimum input signal is reached and
will then display “-O.L”.
To Next Page
Loading...
