• In addition, holiday hours can be set and one holiday date entered. On
the holiday date, the holiday hours will be used instead of the regular
hours. Only one holiday date can be programmed and a new date must be
reprogrammed after each holiday.
• If the SLAVE AFTER HOURS option is enabled, Relay 2 will act as a slave to
Relay 1 outside the programmed hours.
•
Alarm Output.
Relay 2 can be used to turn on an alarm device, such as a siren or strobe,
when an alarm occurs. Any system alarm will trigger this relay.
The hold time for Relay 1 is determined by the controller and not by the APEX
except when extended door controls are used.
APEX Access Device
27
rev. 7-2017 114A3863.E
To Next Page
Loading...
