Standard Display Messages
The APEX has two standard messages and one optional message
that are displayed when the power is on and no other functions
have been selected. The display will switch between the messages
approximately once every 5 seconds. The two standard messages
are the date and time message and the Welcome to…
message. The third message is an optional custom message.
Date and Time Message
The default time and date message. It is the first of two standard
messages that the APEX displays not in use. When the APEX is
configured for reading magnetic stripe or proximity cards, the
bottom line of the display will show Use Card or Press *.
Wednesday 06/22/09
12:01:15 pm
Press * to begin
Welcome to… Message
This is the second standard message display when not in use. The
two middle lines can be changed in the setup function to reflect
the company name, or a greeting. Each line has a maximum of
20 characters. When the APEX is configured for reading magnetic
stripe or proximity cards, the bottom line of the display will show
Use Card or Press *.
Welcome to
Your Storage
Facility
Press * to begin
APEX Access Device
41
rev. 7-2017 114A3863.E
To Next Page
Loading...
