NOTE: In the event the password is changed and then forgotten, disconnect
power from the APEX, then hold the program button while reconnecting power.
This will bypass the password prompt and enter the Setup mode directly. When
using this method, you will be prompted to Restore Factory Defaults. Select Yes to
restore all default factory settings including the site name and password.
APEX Access Device Setup Function
to enter Setup mode
Press the *, 0, and # keys simultaneously
Enter the factory default password: 8898
Press the # key
Press the # key to advance through each setup parameter.
A parameter is automatically saved when you press # and
move to the next parameter.
If the timeout is allowed to occur, the current parameter
will NOT be saved.
Numeric values are entered directly into the unit using
the number keys.
When an option is presented, use the * key to scroll
through the available settings.
There are three (3) ways to exit Setup mode:
• Press the 7, 8, and 9 keys simultaneously
• Go through all of the setup functions
• Press the program button on the circuit board
A timeout is built into the system that will exit Setup mode if
there is no input on the keypad for an extended period of time.
APEX Access Device
32
114A3863.E rev. 7-2017
To Next Page
Loading...
