Figure 34. PPTP VPN settings
Table 10. Parameter details of PPTP VPN
Turns the PPTP client on or off.
Set PPTP server IP or domain name.
Select the interface according to different networking methods.
Username used for authentication to the PPTP server. They are
provided by the VPN server.
These are the IPv4 client-side networks that will be routed to this
client specifically using route, so that a site-to-site VPN can be
established.
Subnet mask of remote client network.
Network address translation. It’s a way to map multiple private
addresses inside a local network to a public IP address before
transferring the information onto the internet.
This option must be consistent with the VPN server.
The MTU value of the PPTP channel must be consistent with the
To Next Page
Loading...