Click Restore Factory Settings, will pop-up a prompt, select OK, all the parameter will be returned to factory
settings, and the device will reboot.
Figure 5.5
3.1.5 Reboot Device
Click Reboot the device, will pop-up a prompt, select OK, then the device will reboot
Figure 5.6
3.2 Network Settings
Click Network, will pop-up the prompt as below:
3.3 Basic Network Settings
Here you can set the camera’s IP address; i.e., set the static IP address of the camera manually.
You can also do the same settings from IP Camera Tool. (Figure 2.3).
To Next Page
Loading...