Terminal Unit Menus
9
Note: The factory default setting for High Level Password is
11111111.
After entering high level password the following screen will be displayed:
1.PROGRAM AUTO
2.PROGRAM S-AUTO
3.PROGRAM MANUAL
PROGRAM AUTO
By choosing PROGRAM AUTO, the following screen will be displayed:
GROUP 1 RCU 01 +
OLD NEW
00 -Min- 00
00.0 -Sec- 01.0
Menu Options:
GROUP: 1 to 8
RCU: 01 to 16
Present: + or –
Min: 0 to 99
Sec: 0.0 to 59.8
For each RCU you have to program the minutes, seconds and tens of seconds as
separate values. The new values of the minutes, seconds and tens of seconds are
inputted, while the old values are displayed as reference. For each PRESENT (+)
unit in a given group the appropriate Command Key LED will go on green.
PROGRAM S-AUTO
By choosing PROGRAM S-AUTO The following screen will be displayed:
GROUP 1
RCU 01
PRESENT +
NUMBER 01
Menu Options:
GROUP: 1 to 8
RCU: 01 to 16
Present: + or –
NUMBER: 1 to 128
For each PRESENT (+) unit in a given group, the appropriate Command Key LED
will go on green. In Semi-Automatic Operation, the NUMBER in the above screen
stands for the order of activation of each RCU in the semi-automatic sequence.
To Next Page
Loading...