Operating the System
17
Programming an Event
Note: If the TU is turned off
, start-up the system as described
in "System Start-Up" on page 16. If the TU is turned on, press Esc
until the main settings menu is displayed.
Note: For details about navigating, selecting options and
entering values, see "Navigating the System" on page 6.
Select Event Number
1. In the main settings menu, select EVENTS CONTROL. The EVENTS
CONTROL screen will be displayed:
1.SELECT EVENT
2.PROGRAM EVENT
3.CLEAR EVENT
4.CHOOSE EVENT
2. Select SELECT EVENT. The SELECT EVENT screen will be
displayed:
SELECT EVENT
Choose event
From 1 to 8
1
3. Select an event number (from 1 to 8), and press Enter. The EVENTS
CONTROL screen will be displayed again.
Select Event Mode
1. Select PROGRAM EVENT. If you logged into the system with Low Level
password, you will be prompted to enter the High Level password.
Note: The factory default setting for High level password is
11111111. For further details about passwords, see page 26.
After entering high level password, the PROGRAM EVENT screen will
be displayed:
To Next Page
Loading...