Operating the System
16
Operating the System
Note: Before operating the system, make sure the TU and
RCUs has batteries. For details, see page 6.
System Start-Up
Insert Master Key into TU and press the Pwr button on the TU.
Command key LEDs will be in the following condition:
Key LED Color
Send Red
Ready Green
Hold Red
Group Green
The start-up screen will be displayed:
19:01:57
EVENT:1 GROUP:1
MODE: MANUAL
1. To start the system, press Esc. You will be prompted to enter the
password:
ENTER PASSWORD
________
Note: The factory default setting for Low Level password is
00000000 and for High Level password is 11111111. For further
details about passwords, see page 26.
2. Enter the password and press ENTER. The main settings menu will be
displayed:
1.EVENTS CONTROL
2.ADD UNITS
3.SET UNITS
4.TU SETTINGS
To Next Page
Loading...