Terminal Unit Menus
10
MANUAL
By choosing MANUAL The following screen will be displayed:
GROUP 1
RCU 01
PRESENT +
Menu Options:
GROUP: 1 to 8
RCU: 01 to 16
PRESENT: + or –
For each PRESENT (+) unit in a given group the appropriate Command Key LED
will go on green.
CLEAR EVENT
On the EVENTS CONTROL screen, select CLEAR EVENT. If you logged into the
system with Low Level password, you will be prompted to enter the High Level
password.
Note: The factory default setting for High Level Password is
11111111.
After entering high level password, the following screen will be displayed:
Event: 1 MANUAL
ENTER - to clear
ESC - to cancel
Menu Options:
EVENT: 1 to 8; MANUAL, S-AUTO, AUTO
The event can be cleared by pressing ENTER, but this will work only with the high
level password only.
CHOOSE EVENT
On the EVENTS CONTROL screen, select CHOOSE EVENT to display the following
screen:
1.AUTO
2.S-AUTO
3.MANUAL
Select AUTO to start an automatic event, S-AUTO to start a semi-automatic event, or
MANUAL to start a manual event.
To Next Page
Loading...