Operating the System
19
When finished, press Esc twice to return to the EVENTS CONTROL screen.
3. PROGRAM MANUAL
If you want to program the manual mode, select PROGRAM MANUAL in the
PROGRAM EVENT screen. The following screen will be displayed:
GROUP 1
RCU 01
PRESENT +
Choose the desired values for GROUP, RCU and Present (+/–).
For each PRESENT (+) unit in a given group the appropriate Command Key LED
will go on green.
When finished, press Esc three times to return to the main settings manu.
Add Units
You have to "teach" the RCUs their address (Group Number and RCU Number) and
also check the system for interference, after placing the RCUs at the display location.
1. Select ADD UNITS. The following screen will be displayed:
1.RCU x 1
2.RCU x 16
3.TEST 1 SEC.
2. Select RCU X 1. The following screen will be displayed:
GROUP 1 RCU 01
3. Enter GROUP number between 1-8, press Enter and input an RCU
number between 1 and 16.
Now you can assign an address to an RCU.
Note: Make sure 9 volt battery is in place and Power is OFF.
Options:
GROUP: 1 to 8
RCU: 01 to 16
PRESENT: + or –
Options:
GROUP: 1 to 8
RCU: 01 to 16
To Next Page
Loading...