B – Command Line Interface
Hardreset Command
59225-00 B B-19
A
Hardreset Command
Resets the switch and performs a power-on self test. This reset disrupts traffic,
activates the pending firmware, and clears the alarm log. To save the alarm log
before resetting, refer to the “Set Log Command” on page B-51.
Authority Admin session
Syntax hardreset
Notes To reset the switch without a power-on self test, refer to the “Reset Command” on
page B-31.
To reset the switch without disrupting traffic, refer to the “Hotreset Command” on
page B-22.
To Next Page
Loading...
Need help?
General
