4 – Installation
Installing a Switch
59225-00 B 4-19
A
To configure the switch using the command line interface, do the following:
1. Open a Telnet session with the default switch IP address and log in to the
switch with default account name and password (admin/password).
telnet 10.0.0.1
Switch Login: admin
Password: *******
2. Open an admin session and enter the Set Setup System command. Enter
the values you want for switch IP address (Eth0NetworkAddress) and the
network mask (Eth0NetworkMask). Refer to “Set Setup Command” on
page B-57 for more information about this command.
SANbox #> admin start
SANbox (admin) #> set setup system
3. Open a Config Edit session and use the Set Config command to modify the
switch configuration. Refer to the “Config Command” on page B-11 and “Set
Config Command” on page B-40 for more information.
4.2.9
Cable Devices to the Switch
Connect cables to the SFP transceivers and their corresponding devices, and
then energize the devices. Device host bus adapters can have SFP (or SFF)
transceivers or GigaBit Interface Converters (GBIC). LC-type duplex fiber optic
cable connectors are designed for SFP transceivers, while SC-type connectors
are designed for GBICs. Duplex cable connectors are keyed to ensure proper
orientation. Choose the fiber optic cable with the connector combination that
matches the device host bus adapter.
GL_Ports self configure as FL_Ports when connected to loop of public devices or
F_Ports when connected to a single device. G_Ports self configure as F_Ports
when connected to single public devices. Both GL_Ports and G_Ports self
configure as E_Ports when connected to another switch.
To Next Page
Loading...
Need help?
General
