4 – Installation
Installing a Switch
4-4 59225-00 B
S
4.2.2
Install Transceivers
The switch supports a variety of SFP transceivers. To install a transceiver, insert
the transceiver into the port and gently press until it snaps in place. To remove a
transceiver, gently press the transceiver into the port to release the tension, then
pull on the release tab or lever and remove the transceiver. Different transceiver
manufacturers have different release mechanisms. Consult the documentation for
your transceiver.
NOTE: The transceiver will fit only one way. If the transceiver does not install
under gentle pressure, flip it over and try again.
To Next Page
Loading...
