B – Command Line Interface
Zoning Command
B-108 59225-00 B
S
save
Saves changes made during the current Zoning Edit session. The system will
inform you that the zone set must be activated to implement any changes. This
does not apply if you entered the Zoning Clear command during the Zoning Edit
session.
Examples The following is an example of the Zoning Edit command:
SANbox #> admin start
SANbox (admin) #> zoning edit
SANbox (admin-zoning) #>
.
.
SANbox (admin-zoning) #> zoning cancel
Zoning edit mode will be canceled. Please confirm (y/n): [n] y
SANbox (admin) #> admin end
To Next Page
Loading...
Need help?
General
