2 – Using QuickTools
QuickTools User Interface
59235-02 A 2-9
L
To select several non-consecutive ports, press the Control key while
clicking each port.
To un-select ports in a group of selected ports, press the Control key while
clicking each port.
To cancel a selection, press the Control key and select it again.
Note: When using the Shift key to select a range of ports, the first port you
click in the range is the "anchor" selection. Subsequent ranges are
based on this anchor selection. For example, after clicking port 4 and
port 9 respectively, port 4 becomes the anchor selection. The next
range includes all ports between port 4 and the next port you select.
To Next Page
Loading...
