A – Command Line Interface
Set Setup Command
A-88 59097-02 B
S
LocalLogEnabled Enables (True) or disables (False) the saving of log infor-
mation on the switch. The default is True.
RemoteLogEnabled Enables (True) or disables (False) the recording of the
switch event log on a remote host that supports the sys-
log protocol. The default is False.
RemoteLogHostAddress The IP address of the host that will receive the switch
event log information if remote logging is enabled. The
default is 10.0.0.254.
NTPClientEnabled Enables (True) or disables (False) the Network Time Pro-
tocol (NTP) client on the switch. This client enables the
switch to synchronize its time with an NTP server. This
feature supports NTP version 4 and is compatible with
version 3. An Ethernet connection to the server is
required and you must first set an initial time and date on
the switch. The synchronized time becomes effective
immediately. The default is False.
NTPServerAddress The IP address of the NTP server from which the NTP cli-
ent acquires the time and date. The default is 10.0.0.254.
EmbeddedGUIEnabled Enables (True) or disables (False) the SANsurfer Switch
Manager Web applet. Changing this parameter to False
while the applet is running will terminate the applet. The
default is True.
Table A-26. System Configuration Settings (Continued)
Entry Description
To Next Page
Loading...
Need help?
General
