A – Command Line Interface
Set Setup Command
59097-02 B A-89
A
Examples The following is an example of the Set Setup RADIUS command:
SANbox xxxx (admin) #> set setup radius
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the attributes
for the server being processed, press 'q' or 'Q' and the ENTER key to do so.
If you wish to terminate the configuration process completely, press 'qq' or
'QQ' and the ENTER key to so do.
DeviceAuthOrder (1=Local, 2=Radius, 3=RadiusLocal) [Local]
UserAuthOrder (1=Local, 2=Radius, 3=RadiusLocal) [Local]
TotalServers (decimal value, 0-5) [1 ]
Server: 1
ServerIPAddress (dot-notated IP Address) [10.20.11.8]
ServerUDPPort (decimal value) [1812 ]
DeviceAuthServer (True / False) [True ]
UserAuthServer (True / False) [True ]
AccountingServer (True / False) [False ]
Timeout (decimal value, 10-30 secs) [10 ]
Retries (decimal value, 1-3, 0=None) [0 ]
SignPackets (True / False) [False ]
Secret (32 hex or 16 ASCII char value) [******** ]
Do you want to save and activate this radius setup? (y/n): [n]
The following is an example of the Set Setup Services command:
SANbox xxxx (admin) #> set setup services
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
*Warning: If services are disabled, the connection to the switch may be lost.
TelnetEnabled (True / False) [True ]
SSHEnabled (True / False) [False]
GUIMgmtEnabled (True / False) [True ]
SSLMgmtEnabled (True / False) [False]
EmbeddedGUIEnabled (True / False) [True ]
SNMPEnabled (True / False) [True ]
NTPEnabled (True / False) [False]
CIMEnabled (True / False) [True ]
FTPEnabled (True / False) [True ]
MgmtServerEnabled (True / False) [True ]
Do you want to save and activate this services setup? (y/n): [n]
To Next Page
Loading...
Need help?
General
