• Observe electrostatic discharge (ESD) procedures to avoid damage to components.
1. Remove the storage controller.
For details, see Removing the Storage Controller.
2. Remove an existing module.
a. Push the retention clips outward simultaneously to release the module.
Warning
Attempting to remove a module that is not completely released may damage the module and
the motherboard.
b. Hold the module by the edges and then carefully slide it out of the slot.
3. Install a new module.
a. Align the notch with the ridge in the slot.
b. Insert the module into the slot.
c. Verify that the metal connectors are completely inserted into the slot.
ES1686dc User Guide
Installation and Configuration 32
To Next Page
Loading...
Need help?
General
