EasyManuals Logo

QNAP QHora-321 User Manual

QNAP QHora-321
70 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
2. Installation and Access
This chapter provides specic hardware installation and router access steps.
Installation Requirements
Category Item
Environment Room temperature: 0˚C to 40˚C (32˚F to 104˚F)
Non-condensing relative humidity: 5% to 95%
Wet-bulb temperature: 27˚C (80.6˚F)
Flat, anti-static surface without exposure to direct sunlight, liquids,
or chemicals
Hardware and peripherals Network cable
Tools Anti-static wrist strap
Setting Up the Router
1. Place your router in an environment that meets the requirements.
For details, see Installation Requirements.
2. Power on the router.
For details, see Rear Panel.
3. Verify that the power LED is yellow-green and the system status LED is orange.
For details, see LEDs.
4. Connect the router to the network and the computer.
For details, see Connecting the Router to the Internet.
5. Verify that the WAN interface LED is orange and the LAN interface LED is green.
For details, see LEDs.
6. Log on to QuRouter with the local account credentials or QNAP ID.
For details, see Binding the Router with a QNAP ID.
Connecting the Router to the Internet
1. Connect the router to the power source.
a. Connect the power cord to the router.
b. Connect the power adapter to the electrical outlet.
The router powers on.
2. Connect the router to the internet.
a. Connect an Ethernet cable to the WAN port of the router.
b. Connect the other end of the Ethernet cable to the ISP gateway or the modem.
3. Connect the router to the computer.
QHora-321 User Guide
Installation and Access 9

Table of Contents

Other manuals for QNAP QHora-321

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the QNAP QHora-321 and is the answer not in the manual?

QNAP QHora-321 Specifications

General IconGeneral
DSL WANNo
Ethernet WANYes
Networking standardsIEEE 802.1Q, IEEE 802.3, IEEE 802.3ab, IEEE 802.3bz, IEEE 802.3u, IEEE 802.3x
Concurrent connections50000
Ethernet LAN data rates100, 1000, 2500 Mbit/s
Ethernet interface type2.5 Gigabit Ethernet
Flash memory4 MB
CertificationCE / FCC / VCCI / BSMI / RCM / CCC / UKCA
Storage mediaFlash
Internal memory4096 MB
Processor modelCN9130
Processor frequency2.2 MHz
Internal memory typeDDR4
Processor manufacturerMarvell
Internal storage capacity4 GB
Web-based management-
Output voltage12 V
Power source typeDC
Power consumption (typical)36 W
Package weight1350 g
Cables includedAC, LAN (RJ-45)
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)5 - 95 %
Ethernet LAN (RJ-45) ports6
Product colorWhite
VPN supportL2TP, WireGuard, OpenVPN, QBelt
Firewall securityTCP, UDP, ICMP, TCP+UDP
Weight and Dimensions IconWeight and Dimensions
Depth145.7 mm
Width166.4 mm
Height29.85 mm
Weight810 g

Related product manuals