3. Basic Operations
This chapter describes basic device operations.
LEDs
LEDs indicate the overall status of the router power, network ports, and system status.
Note
• Front panel LEDs remain active during the entire reset process.
• The default WAN interface designation is assigned to port number 1.
LED Status Description
Power Yellow-green The router is powered on.
O The router is powered o.
Flashes yellow-green every
1 second along with the
system status LED
A system error occurred.
System Status Orange The router is powered on and initializing.
Flashes orange every 1
second
The router is being initialized.
Flashes orange every 1
second along with the power
LED
A system error occurred.
Flashes orange every 2
seconds
The rmware is being updated.
O The router is powered o.
QuWAN
Orchestrator
status
Blue-green The router has joined the QuWAN Orchestrator topology
and is connected to the SD-WAN network.
Flashes blue-green every 0.5
seconds
The router is joining the QuWAN Orchestrator SD-WAN
network.
Flashes blue-green every 2
seconds
The router lost connection to the QuWAN Orchestrator SD-
WAN network.
O The router is not part of the QuWAN Orchestrator SD-WAN
network.
Auto-mesh
Connection
Status
White Connected: All the mesh VPN tunnels established by the
device on the QuWAN Orchestrator SD-WAN network are
accessible.
Flashes white every 2
seconds
Partially connected: Few of the mesh VPN tunnels
established by the router on the QuWAN Orchestrator SD-
WAN network are inaccessible.
O The router is not part of the QuWAN Orchestrator SD-WAN
network.
2.5 Gigabit
Ethernet (2.5
Gbps speed)
Green The network connection is operating at 2.5 Gbps.
Flashes green Data is being transmitted.
O There is no network connection.
QHora-321 User Guide
Basic Operations 13